Noodlesoft Forums

I am trying to change the file name based on the contents of a text file. I created a simple text file with a few words in it. One of them being the work Law.

My rules are:

Any File (In a specific folder)
Contents Contain Match (For the word Law. It then changes it to Law (empty)

Then rename with the following attributes:

Law (empty) - Test


When the rule runs it only renames the file to: - test

I can't figure out where the problem is. This should be super simple I would think.

Any suggestions?

Can you post a screenshot? I'm not quite sure from your text description if you are using a custom attribute or plain text here.